So the speaker now built we need to place the sockets in ready for the driver. To do this we used a larger drill the size of the socket created a hole for the two speakon sockets to sit in. Once the sockets were in place we then fixed them using very small screws.
Now that the main cabinet and inner sections were placed and secure we could then work on the outer part of the box. Where the screw sections of the box could be seen and also the edges of the cabinets were slightly even from the original cutting. We then chose to sand the entire box. This took a considerable amount of time using and electric sander.
We then also discovered that the screw sections might need to be filled. Due to the nature of the cabinets use we would need some thing strong to cope with amount of sanding and pressure. We chose to use car body filler. This HAS to be used with caution it is very potent and very sticky and must be used quickly and correctly. So the screw marks were filled in and sanded down. Not a bad job!
The first of many is now ready for the driver.
This process took four hours.
No comments:
Post a Comment